Easyn F Series User manual Manuel d'utilisateur télécharger pdf (Page 6)

English EasyN IP Camera User Manual

www.easyn.com MFE-E-A3

2.1. Interface

The back of a non-extended line IP Camera:

Power Supply Light: constantly on when power is on

Network light: constantly flashing which indicates data transmission when power is

on.

Ethernet interface: RJ-45 interface.

I/O interface: 1 for alarm input, connect 3 & 4 these two terminals (input terminal

grounding, low level effective trigger); 1 for TTL control input, connect

1& 2 these two terminals.

Power input interface: connect directly to 5V current Power

Extension line IP Camera:

Power: direct current 5V.

GPIO alarm interface: accept external connection linking to alarm equipment (for

example: door magnet, infrared)

Reset line: Short circuit the two lines to power off, then power on for 10 seconds to

return back to default setting

Ethernet interface: RJ-45 network interface.

Backup: follow-up product extend interface.

About GPIO alarm interface (S terminal) definition:

1# +DC12V

2# RS485（A）

3# Earth（GND）

4# IO2 （OUT PUT）

5# RS485 （B）

6# IO1 （IN PUT）

GND: Ground，alarm input ground，RS485

ground

RS485: RS485 control interface，left

connection RS485 negative right connection RS485 positive. connect to P/T decoder，

support various PTZ protocol.

1 2 3 4 5 6 7 8 9 10 11 ... 25 26

Pas de commentaire

Easyn F Series User manual Manuel d'utilisateur Page 6